Now all codes are cleared and car’s immobilizer light is off. Then you need to remove key and plug it in again. Click “Clear Fault Codes” and the code “P1614-50 Wrong Transponder Key” still exist. Remove the existing working key and, within five seconds, insert a second working key and turn it to ON (RUN) then back OFF. Turn the ignition cylinder to ON (RUN) and back to OFF. Insert an existing working key into the ignition cylinder. Yes, once you have had the new key cut by a Locksmith use the following instructions. Then programme key and check fault codes.If wrong Environment identifer fault codes in any other module like airbag,abs, then reset that module, one at a time and taking. Reset BCM (virginate), switch off and take key out and leave for few seconds, then go into immo and BCM intalled and put pin code, switch off and take key out for few second.
0 Comments
Leave a Reply. |